Conversion of a Missouri River Dam and Reservoir to a Sustainable System: Sediment Management1

Abstract: A present and future challenge for water resources engineers is to extend the useful life of our dams and reservoirs. Ongoing reservoir sedimentation in impoundments must be addressed; sedimentation in many reservoirs already limits project benefits and effective project life. Sustainability requires that incoming sediment be moved downstream past the impounding dam. We use Lewis and Clark Lake, the most downstream of the six Missouri River main stem reservoirs, to demonstrate how a reservoir in advanced stages of its project life could be converted to a sustainable system with local benefits exceeding costs by a factor of 1.5. Full consideration of benefits would further enhance project justification. The proposed strategy involves four phases that will take about 50 years to complete. Cost estimates for this potential project range from the quantitative to the plausible, but it is clear that the results justify a full engineering, environmental, and economic study of this model project. If implemented, the project will create scientific knowledge and develop technologies useful for achieving sustainability at many other reservoirs in the Mississippi River basin and beyond.     

考虑油滴碰撞聚结的斜板除油过程模拟

考虑离散油滴在油田废水除油过程中发生的油滴碰撞聚结现象,模拟得出斜板除油器内全部油滴的动态信息,用于斜板除油器除油效率的计算.对矩形同向流斜板除油过程的模拟研究表明:油滴的碰撞聚结会增加斜板除油的效率;当废水的原始含油浓度增大时,斜板除油的效率会增大,碰撞聚结对除油效率提高的影响也越大;废水流动速度提高及斜板的倾斜角度增加均会使斜板的除油效率降低,但此时油滴碰撞聚结对除油效率的影响仍很明显.     

六自由度气锤振动技术与电磁斜面振动技术比较

六自由度气锤振动与电磁斜面振动是两种模拟产品三轴振动的振动技术。由于两种振动技术的机理不同，其对样品的振动影响也会有区别。本文研究讨论两种不同振动技术的不同特点，以及对不同产品的振动效果别，我们可以根据样品特点和测试需求，选择更合适的震动技术。     

崇明东滩不同部位的季节性沉积研究

2002年4月至2003年4月，通过对崇明东滩南部、中部和北部的标志桩观测以及实地观测分析，发现崇明东滩在一年中不同季节冲淤变化过程存在很大差异：春季到夏季，南部以冲刷为主，中部和北部以淤积为主；夏季到秋季，南部和中部以淤积为主，北部表现为冲刷；秋季到冬季，南部、中部和北部都以冲刷为主；头一年冬季到次年春季，南部和北部以淤积为主，中部则表现为冲刷。在同一观测路线上，不同季节高、中、低潮滩冲淤也存在一定差异。通过对沉积物粒度、水体含沙量等指标的测试，并借助潮差等资料，探究了影响潮滩季节性沉积的因素，发现潮滩季节性沉积与潮滩基础地貌、水体含沙量、水动力、潮流等有密切关系；但在不同部位不同季节，各因素对潮滩冲淤影响程度各不相同。     

液-固流化床回收印刷线路板中金属的研究

根据废弃印刷线路板中材料密度不同，采用水介质流化床对印刷线路板粉末中的金属进行回收，对0.25～0.177、0.177～0.104、0.104～0.074和-0.074 mm 4个粒级范围内的物料进行分选试验。试验结果表明，在上述4个粒级范围内，随介质流速的增大，金属回收率降低；金属回收率η与实际操作速度（ua）和颗粒终端沉降速度（ut）的比值φ（ua/ut）存在一定线性关系，分析模拟了η与φ之间的相关性方程，外推试验的结果证明了相关性方程的可靠性；在合适的操作条件下，各粒级范围内金属的回收率分别为95.02%、90.07%、87.5%和92.68%。     

废弃印刷线路板碘化法浸金研究

针对碘化法从废弃印刷线路板中提取金的工艺设计，分别考察了碘的质量分数、n(I₂)/n(I^-)比值、固液比、双氧水的质量分数、pH值、浸出时间和浸出温度对金浸出率的影响。结合正交设计优化实验方法,提出了从废弃印刷线路板中碘化法浸取金的最佳工艺条件：碘的质量分数为1.1％，n(I₂)∶n(I^-)=1∶10，双氧水的质量分数为1.5％，浸出时间4 h，固液比为1∶10，浸出温度为常温（25℃），溶液pH值为中性，此时金浸出率可达97.5％。     

织物染色、印花生产废水处理技术

采用混凝沉淀酸化水解悬挂链曝气生物碳组合工艺处理织物染色、印花生产废水。处理后出水CODCr≤100mgL,去降率≥93%;各项水质指标均稳定的达到了(GB428792)纺织染整工业水污染物排放一级标准。     

Thermal cracking of waste printed wiring boards for mechanical recycling by using residual steam preprocessing

Mechanical waste-processing methods, which combine crushing and separation processes for the recovery of valuable materials, have been widely applied in waste printed wiring board (PWB) treatment. However, both the high impact toughness and the tensile and flexural strengths of whole PWB with a laminated structure result in great energy consumption and severe abrasion of the cutters during multi-level crushing. In addition, the high temperatures occurring in continual crushing probably cause the decomposition of the polymer matrix. A thermal-crack method using residual steam as the heating medium has been developed to pre-treat waste PWBs. This treatment reduces the mechanical strength in order to improve the recovery rate of valuable materials in subsequent mechanical recycling. The changes of the PWBs’ macro-mechanical properties were studied to evaluate thermal expansion impacts associated with changes in temperature, and the dynamic dislocation micro-structures were observed to identify the fracture mechanism. The results showed that thermal cracking with steam at the temperature of 500 K can effectively attenuate the mechanical properties of waste PWBs, by reducing the impact, tensile and flexural strengths respectively, by 59.2%, 49.3% and 51.4%, compared to untreated PWB. Thermal expansion can also facilitate the separation of copper from glass fiber by reducing peel resistance by 95.4% at 500 K. It was revealed that the flexural fracture was a transverse cracking caused by concentrated stress when the heating temperature was less than 500 K, and shifted to a vertical cracking after exceeding 500 K.     

Effects of alfalfa coverage on runoff, erosion and hydraulic characteristics of overland flow on loess slope plots

An evaluation of the interactions between vegetation, overland and soil erosion can provide valuable insight for the conservation of soil and water. An experiment was conducted to study water infiltration, runoff generation process, rate of sediment erosion, and hydrodynamic characteristics of overland flow from a sloping hillside with different draw-off discharges from alfalfa and control plots with 20° slope. The effect of alfalfa on runoff and sediment transport reduction was quantitatively analyzed. Alfalfa was discussed for its ability to reduce the overland flow scouring force or change the runoff movement. Compared to the bare-soil plots, alfalfa plots generated a 1.77 times increase in infiltration rate. Furthermore, the down-slope water infiltration rate for the bare soil plots was higher than in the up-slope, while the opposite was found in the alfalfa plots. In addition, alfalfa had a significant effect on runoff and sediment yield. In comparison to the control, the runoff coefficient and sediment transportation rate decreased by 28.3% and 78.4% in the grass slope, respectively. The runoff generated from the alfalfa and bare-soil plots had similar trends with an initial increase and subsequent leveling to a steady-state rate. The transport of sediment reduced with time as a consequence of the depletion of loose surface materials. The maximum sediment concentration was recorded within the first few minutes of each event. The alfalfa plots had subcritical flow while the bare-soil plots had supercritical flow, which indicate that the capability of the alfalfa slope for resisting soil erosion and sediment movement was greater than for bare soil plots. Moreover, the flow resistance coefficient and roughness coefficient for the alfalfa plots were both higher than for the bare-soil plots, which indicate that overland flow in alfalfa plots had retarded and was blocked, and the flow energy along the runoff path had gradually dissipated. Finally, the ability to erode and transport sediment had decreased.     

一种新型平流式沉淀池运行效果研究

在进水口加设调流板、溢流堰上沿水流方向设置溢流槽两个方面对传统平流式沉淀池进行了改进,设计提出了一种新型平流式沉淀池。通过试验研究分析了调流板和溢流槽对泥砂沉淀效果的影响,得出新型平流式沉淀池可以大大提高泥砂的沉淀效率,出池水流平均含砂量最大降幅可达94.8%,特别是对细颗粒泥砂的沉淀具有较好的效果。